Extruding Rotary Die

For emergency shutdown, press the host stop button and stop the pump motor 1. Close the hopper gate, production finished hopper remaining material2. At the end of the last cycle, turn the function selector switch to the manual position 3. Press the seat back button to manually back out. 4. Open the safety door, clean the mold cavity debris, rust inhibitor, manual closing, close the cooling water, stop the cooling wind5. Place all buttons in the off position (i. e. reset)6. Turn off motor, pad, main power switch 7. Clean up machine wipe clean, clean the floor, the items put back into place

start machine prepare working as below : 1. Open the main power switch of the electric box, close the single-stage switch, switch the operation mode to the adjusted position, the indicator light is bright, indicating that the power supply is on. 2. Open the heating switch on the control panel, adjust the controller, set the electric heating temperature of the material tube, when the set temperature (red light display) can start the host 3. Check the emergency stop switch is valid 4. Reset the switches on the control panel, the proportional valve controller dial switch to remember the total...

Pre-boot preparations, 1. Check the buttons, operation handles, electrical circuits, such as damage or failure, whether the switch handle is in the position. 2. The safety door is the guide rail on the move is flexible, can trigger the formation of a switch. 3. The length of the screw of the mechanical safety device is adjusted to the proper position, which can really play a protective role. Four. Check whether there are any sundries or metal parts in the feeding mouth of the barrel 5, connect the cooling water 6. Add proper amount of Lube Oil to each Lube Point on the slide block surface 7....